English to Turkish Tech/Engineering Engineering (general)

The Loft option creates surfaces by blending a minimum of two curves or chains of curves. This option and the Ruled option function the same and create similar surfaces; however, a loft surface is a smooth blending of the curves, and a ruled surface is a linear blending of the curves.
When you select curves for a loft surface, it is important that you pay attention to where you select each curve or chain of curves because the selected ends of each pair of curves (curves one and two, curves two and three, etc.) compose one edge of the surface. When you select a curve or chain of curves, the system places a temporary arrow at the closest endpoint to show which end you have selected. In order to better match your curves or chains of curves, you may want to select your curves using the Sync chaining method , which lets you match curves manually or by entity, branch, node, or point.

After you select the curves that you want to use to create the loft surface, the default parameter values display in the prompt area, and the Lofted surface parameters menu displays to let you change these values, if needed. Click on the menu below for more information.